Browsing Craigslist, and found a low miles '95 K75 engine for 70 bucks, less the water pump, fuel injectors, with the clutch. I'm going to put it on my bike, when I am replacing the clutch, as my 100k engine is getting a bit tired (uses a good amount of oil, blowby, etc). Leaks in a few places too.
However, before I put it on, I may go through the engine to make sure it is fresh, break the glaze on the cylinders to make sure I can seat the rings/break-in as I would like, reseal, etc.
Any thoughts?