Hi this is my first post and first time working on my 1993 K1100.
Little information before: I have a 1993 K1100 RS that I made into a cafe racer and decided to install the Motogadget M-Unit I did all the wiring myself with the help on the OEM wiring diagram, I did NOT touch the Motronic unit or the harness.
After all the wiring is done I’m not getting spark/fuel injected, fuel pump works fine, the motronic unit is receiving power and delivering the power to the injectors and the coils, but at the moment of cranking the engine it doesn’t send the signal, I have power in all connectors as they should (I checked a lot of posts about injectors and coil problems) all my grounds are connected and the motronic case is grounded to the chassis. so my question is:
Is there any sensor that would prevent spark/fuel signal delivery? Like the HES, the Densit or, TPS?
I already have the stand switch and the clutch switch bypassed.