The motivation has been tough to come by, but here we go!
I finally took time to check a few things over the weekend.
I tested the EFI, Water Temp between pin 10 and ground- 2.5K ohms @ 20C my reading was 4.07 ohms at 10C (does the key need to be in the on position when testing the water temp?)
Airflow meter Pin 7-5 65 ohms, pins 7-8 320 ohms, Pins 5-8 360 ohms, pin 7-8 214 ohms
At this point, it looks like the temp sensor needs replaced, the Airflow Meter readings looks fine to me, of I'm mistaken please let me know.
I also oredered a new fuel line return fuel valve, to hopefully stop the return fuel line from bursting and spraying fuel on me as I ride.
Any other advice to help get this brick running again is welcome.
Supershooter