Hi!
I've resumed my k75 project, and changed the original speed board for a bep3.0 in order to get correct speed, and all the different signals.
I'm having some issues with the fuel wire. In the manual, it shows that if it has float (it's a '93), i the signal is get from the yellow wire from the tank connector.
As I understand, I don't have to pick up the white wire from the original harness to the original gauge, instead of this, I have to use the yellow wire from the connector, but where I have to connect? In the position of the white in the BEP3.0? Or directly to the Gauge?
Anyone has connected to float type bike and works?
Regards!
