Got it, thanks.
Related to wiring:
1. Did you redo a lot of the wiring harness with the m.unit wiring kit? Or were you able to disassemble and tap into the existing pretty easily? I know you used the m.button so that was all fresh. More curious about the other bits rearward of the handlebars.
2. In retrospect, without needing the BEP 3.0, do you think you could have fit the ECU under the tank as well?
Related to your intake:
1. Was the boxed section you folded from aluminum done for ease of fabrication or to create enough volume to match the stock air box for intake tuning reasons?
2. How did you affix the 38mm tubes to the throttle bodies? Looks like maybe you used the short stock bits as an interface, but I couldn't see clamps or anything.
3. Are those 38mm elbows off the shelf pieces you can buy?